Plan you sewer system to function for the long term
Plan you sewer system to function for the long term
Drainage pipes are used in the system of removing effluent from utilities to the sewer or septic tank. They are also used in the sewer system in our homes where they are used in between the inspection chambers. The system must be able to clean itself without blockage. Appropriate gradients are used to accomplish this. Drain lines mostly comprise of UPVC tubing. It is important to adequately test the laid system before its commissioning. The testing has to be conducted on the drain lines running between the chambers.
Drainage pipes need to be laid down in channels dug in the earth. Three hundred to five hundred millimeters is the typical depth adopted. Such sewer systems are enclosed in concrete when they pass below driveways, walkways or under a parking. Before the construction of the drains, it is better to dig the earth to the recommended levels and check the gradients. The grading must be done near the sewers or the tank. Maintain a slope of one in four for the excavated channels. The bottom of the trenches must be well compressed and jammed to give a secure base. Fix pegs at the base of each trench to set the required levels.
The drainage pipes should never be laid down haphazardly, they are to be put in a straight line. The pipes should be connected with sockets leading uphill or in the direction of the building. The sewer system should be placed on a solid, smooth and flat ground. Male and female sockets should be used to join the pipes using a good adhesive. Make sure that you follow all the instructions for the adhesive, as specified by the manufacturer. The drainpipe should go completely into the wall’s thickness as they are being joined to the inspection chambers. Keep debris off the pipes.
Inspect and scrutinise the drainage pipes while laying them. This is important to make sure that there is no leakage. Make certain that the hooks of the sockets are firmly fixed in the foundation. They should also be kept as short as possible. The inlet and outlet points must be evened out and marked appropriately. After fixing all the joints properly, the system then needs to be wrapped up with soil. Connect to the sewer or septic tank. The drainage system is now ready once you connect to the utilities.